Modbus Organization

Advantages of Joining | Join Form | Toolkit | Subscribe to Newsletter

Text Size: smallmediumlarge
 Back to Company

 

Type:  Modem
Description:  Grayhill offers the EZCom-IP family of wireless Industrial Radios. EZCom-IP is sold two ways, depending upon the application. In simple point-to-point applications, the EZCom Bridge is a pre-configured radio, which acts as a wire replacer when wiring is uneconomical or impossible. The EZCom-IP Router is intended for more complex point-to-multipoint or multiple-access networking. More sophisticated IP address configuration is accomplished using EZCom-IP Explorer. EZCom's network controller packetizes the data prior to transmission, which provides communication handshaking, error detection, packet sequencing, and supports up to 128 route entries to extend the communication range. For error detection, EZCom uses a Cyclic Redundancy Check (CRC) with automatic packet retransmit. The EZCom-IP radio is based on spread spectrum technology with direct sequence spreading for enhanced interference immunity, reliability, and extended range. Additional reliability is provided through built-in, out-of-band filtering. Multiple Access Networking is achieved through the use of Carrier Sense Multiple Access/Collision Avoidance (CSMA/CA) shared media etiquette. The transceiver can be programmed to use different RF channels and different PN codes allowing collocated networks to operate independently. EZCom's data port is a standard 10BaseT-Ethernet interface.
Connectivity:  Modbus TCP/IP
Features:  2.4-GHz Spread Spectrum-Direct Sequence; up to 5 Mile (8.045 km) range in open environments; IP routing; store-and-forward routing capability; high-speed 1MB or 2MB data rate; attached or remote antenna; industrial temperature range; panel or DIN rail mount; Grayhill EZCom-IP Explorer Setup and Configuration software; auto cable detect- (no hub needed); exceptional receiver sensitivity
Specifications:  Transceiver Waveform: Direct Sequence Spread Spectrum RF Frequency Band: 2.4-GHz ISM Band Frequency Channel Spacing: 1 MHz Communication Mode: Half duplex Chip Rate: 11 Mcps Channel Burst Data Rate: 1 or 2 MBps Processing Gain: 10.4 dBm minimum Receiver Sensitivity at 10 -6 BER: -83 dBm Transmitter Output Power: 25 dBm minimum Spurious Output: Compliant to FCC Part 15 LED Indicators: Power, signal strength, RF transmit, RF receive, and Ethernet activity link. Range: Up to 5 miles (8.045 km) in open environments; high gain antennas may allow greater range to be achieved. Data Interface Connector: Ethernet RJ45 Power Connector: Lemo receptacle, 3-pin, connects directly to the Grayhill Power Supply p/n WL-PWR-AC1. Data Interface Type: RJ-45 Ethernet 10BaseT Communication Mode: Half Duplex Power Requirements Supply Voltage: +10 to +28 Vdc Max. Power Consumption: 14.4W Tx Supply Current: 1200 mA at +12 Vdc Rx Supply Current: 600 mA at +12 Vdc
 

(Specification Sheet)